Y. Delete a DHCP Assignment Entry

Deletes an assigned IP address from the Display DHCP Server Assigned Addresses command. Type the IP address to delete, and then press ENTER.

N.Configure

NAT

Displays the NAT Configuration Menu, which contains the following commands to configure the Network Address Translation (NAT).

NAT allows you to use one IP address of every workstation in your company. This hides your internal Intranet addresses.

You must restart the PARTNER ACS 1600 DSL module for the changes to take effect. For more information on restarting the PARTNER ACS 1600 DSL module or on upgrading your software using TFTP, see the “PARTNER ACS 1600 DSL module basics” chapter.

B. Enable/Disable NAT Debug Messages

Enables and disables NAT debugging messages.

P. Enable/Disable NAT Translation by Port

Enables and disables NAT by port. Type the number of the Interface, the number of the port to enable, and then press ENTER. You must enable NAT for all ports that connect to the Internet.

T. Configure NAT TCP Timeout

Sets the NAT TCP Connection Timeout, a value between 60 - 3,600 seconds (default = 300 seconds). Type the TCP Timeout value, and then press ENTER.

U. Configure NAT UDP Timeout

Sets the NAT UDP Connection Timeout, a value between 60- 3,600 seconds (default = 120 seconds). Type the UDP Timeout value, and then press ENTER.

R. Configure NAT Port Range

Sets the range of port numbers to assign to IP connections, with a low value between 5,000-65,534 (default = 50,000) and a high range between 50,000-65,535 (default = 65,535).

The size of the NAT port range defines the number of simultaneous connections permitted. a small port range limits

Avaya, Inc.

- 70 - PARTNER ACS 1600 DSL module User Guide

Page 71
Image 71
Avaya 1600 manual Delete a Dhcp Assignment Entry, Enable/Disable NAT Debug Messages, Enable/Disable NAT Translation by Port