Avaya 1600 manual VoicePath Configure, Set Voice Gateway, Set Jitter Delay

DLCI number and encapsulation type to RFC1490 or RFC1483. . If you do not enter any optional parameters, it finds the first available slot, interface, port and connection.

set nat <on or off> (slot) (interface) (port) – sets NAT on or off. . If you do not enter any optional parameters, it finds the first available slot, interface and port.

set dns server address <DSN server IPaddress> - sets the DNS server IP address.

set system defaults – sets the system to the default parameters.

show configuration – displays the current configuration.

show ip routes – displays the IP route table.

ping <IPaddress> (size of pings) (number of pings)

– pings an IP address.

P.VoicePath Configure

Displays the Voice Configuration submenu, which contains the following commands:

V. Set Voice Gateway

Displays the Voice Gateway Selection submenu, which contains the following commands to set the voice gateway.

0.No Voice Gateway

1.MGCP 0.1/NCS 1.0

2.CopperCom

3.JetStream

4.TollBridge

Select your choice.

J. Set Jitter Delay

Sets the jitter delay, a value between 0 and 50 ms (default = 0 ms).

Jitter delay is defined by equation as: Jitter Equation [CASZ97]2

Inter-arrival jitter is the difference in relative transit time for two packets. It is the difference between the packet's RTP time-stamp and the receiver's clock at the time of arrival of the packet.

Avaya, Inc. - 76 - PARTNER ACS 1600 DSL module User Guide