Your settings display in the Display Current Configuration command in the Reports Menu. For more information, see "Reports Menu" earlier in this chapter.

You must enable bridging both globally and by port number, and then restart the PARTNER ACS 1600 DSL module for any changes to take effect. For more information on restarting the PARTNER ACS 1600 DSL module, see the “PARTNER ACS 1600 DSL module basics” chapter.

G. Enable/Disable Bridging Globally

Enables and disables bridging for all installed interfaces.

P. Enable/Disable Bridging by Port

Enables and disables bridging by port.

Type the number of the Interface to enable or disable, and then press ENTER.

A. Configure Bridge Aging Timer

Sets the bridge database aging time, a value between 1-3,600 seconds (default = 300 seconds). Type the bridge aging time value, and then press ENTER.

The PARTNER ACS 1600 DSL module displays a default or last-used value in parentheses to the left of the command prompt. To accept this value, press ENTER.

The time counts down in one-second intervals; at zero, the entry deletes from the database.

T. Enable/Disable Spanning Tree Globally

Enables and disables the Spanning Tree protocol for all installed interfaces.

O. Enable/Disable Spanning Tree by Port

Enables and disables the Spanning Tree protocol for the selected Interface.

Type the number of the Interface, and then select enable or disable.

R. Configure Spanning Tree Bridge Priority

Sets the Spanning Tree bridge priority, a value between 1- 65,565 (default = 32,768). Type the Spanning Tree bridge priority value, and then press ENTER.

The PARTNER ACS 1600 DSL module displays a default or last-used value in parentheses to the left of the command prompt. To accept this value, press ENTER.

Avaya, Inc.

- 41 - PARTNER ACS 1600 DSL module User Guide

Page 42
Image 42
Avaya 1600 manual Enable/Disable Bridging Globally, Enable/Disable Bridging by Port, Configure Bridge Aging Timer