Avaya 1600 manual Enable/Disable RIP, Configure RIP Version by Port

T. Remove the Default Route

Deletes the default static route from the Route Table. Type the IP address to remove, and then press

ENTER.

D. Display Route Table

Displays the following information about statically configured routes and dynamically learned ones:

•NETWORK ADDRESS - destination address.

•NETMASK - IP subnet mask; number of bits reserved for the host ID.

•GATEWAY ADDRESS - IP address of packets sent to destination.

•interface - IP address of outgoing interface.

•Metric - number of hops (routers) required to reach the specified gateway.

•Type – static or dynamic.

R. Enable/Disable RIP

Enables and disables the Routing Information Protocol (RIP). RIP sends routing information from one router to adjacent routers, dynamically "learning" network topology.

When you enable RIP, the PARTNER ACS 1600 DSL module stores sent routing information in the Route Table. For more information on the Route Table, see "Reports Menu" earlier in this chapter.

V. Configure RIP Version by Port

Sets the RIP version for the selected port.

Type the number of the Interface, the port number, and then select one of the following RIP Versions:

0.Disabled

1.Version 1 Broadcast

2.Version 2 Broadcast

3.Version 2 Multicast

P. Configure RIP Poisoned Reverse by Port

Enables and disables RIP Poisoned Reverse for the selected interface.

Type the number of the Interface, and then enable or disable.

Avaya, Inc. - 32 - PARTNER ACS 1600 DSL module User Guide