Avaya 1600 manual Select Configure Port IP Address

2.Select Configure Port IP Address.

The following instructions display on-screen:

Available Interfaces :

1.SDSL

2.10/100BaseT Ethernet

3.Universal Serial

0.(Abort)

Selection :

Interfaces may or may not display, depending on the IAD in use.

3.Type the number of the port for which you want to configure an IP address.

The following message (or one similar) displays:

IP	interfaces on port 1:
ID	IPAddr	IPMask	Priority
0	255.255.255.0	255.255.255.0	NORMAL

Enter connection to configure:

4.Type the ID number of the connection that you want to configure (range = 0-7), and then press ENTER.

5.Type the new IP address, or press ENTER to select the current IP address.

The following instructions display on-screen:

Current subnet mask = 0.0.0.0

Enter new subnet mask for this interface:

6.Type the new subnet mask address, or press ENTER to select the current subnet mask.

The following instructions display on-screen:

Select priority Normal/High [N/H] (N):

7.Do one of the following, and then type Y:

To give the interface high priority, type H.

To give the interface normal priority, type N.

8.Repeat steps 1-6 for each port for which you want to configure an IP address.

You must restart the PARTNER ACS 1600 DSL module for any changes to take effect. For more information on restarting the PARTNER ACS 1600 DSL module, see the “Getting started” chapter.

You can now run the Telnet program.

Avaya, Inc. - 18 - PARTNER ACS 1600 DSL module User Guide