Brady label maker manual Naming supply colors, To supply names for new ribbons or tapes

Cutter	Color & Cut system only. Re-sets the
Calibration:	factory-set calibration values for the plotter
Horizontal (x)	cutter in your system. Enter positive or
Vertical (y)	negative whole numbers to adjust the
	horizontal or vertical values by one/one
	thousandth of an inch for each increment.
	Note: Use caution when calibrating your
	plotter cutter. To return to the factory-
	set values, see the calibration label
	placed inside your printer at the
	factory, and reinstate the values
	shown on that label.
	See Calibrating the Cutter on page 10-12
	for more information.

Naming supply colors

When new tape or ribbon supplies become available after your print system is shipped to you, your system will not have internal information about those new supplies. The Check Supply Colors button lets you supply the names of new supplies and store them in your system.

To supply names for new ribbons or tapes

1.Install the new tape or ribbon in your system.

2.Choose the Check Supply Colors button on the Hardware options tab.

5-8°Setting Hardware Tab Options