supported length restriction of 38”. The label shown on the screen is over 38” long. Note that the display indicates the cutoff point at 38”.
If you attempt to print this label as it is, the printer truncates the job at the maximum length of 38”, without displaying a warning message. The part of the circle that extends beyond 38” does not print, just as shown on the display screen.
Non-truncating conditions
You see the actual set label length on your display screen, and the system will not automatically truncate a label that exceeds the maximum length allowed for the supplies installed, under these conditions:
When you create a label with continuous color ribbon installed, with single color objects, unless the objects you added to the label extend beyond the 100” maximum length for this type print job.
When the length is set for the label, either by you when you create
zthe label, or by the template you used to create the label.
When you save your label, then retrieve it again with a panel ribbon installed, you will see the actual set label length indicated on the screen.
In these cases, when you attempt to print the label, the system displays a Label Too Long message, and you must correct the label before proceeding.
Cut out label length
The maximum length for cut out labels is 38” or 965 mm. See CHAPTER 10: Working with
Printing
