NOTE

•Even if you set Different Paper Sizes for the Output Tray to 'Off', different paper sizes are output to the same output tray in the same way as when Different Paper Sizes for the Output Tray is set to 'On' when outputting to the Copy Tray-J1 or Buffer Pass Unit-E2.

•Even if you set Different Paper Sizes for the Output Tray to 'Off', different paper size may be output to the same output tray if there is only a small amount of paper in the paper tray.

Clean the Original Scanning Area Prompt

You can use the Cleaning Display for the Original Scanning Area mode to prompt you to clean the scanning area when the machine detects streaks or stains. If the feeder is not clean, the machine will scan and print dust and grime on the output.

The Clean the Original Scanning Area Prompt appears when originals are placed in the feeder. For instructions on cleaning the feeder's scanning area, see "Manual Feeder Cleaning," on p. 7-53.

NOTE

[Cleaning Display for the Original Scanning Area] appears only if the optional Feeder (DADF-N1) (standard-equipped for the imageRUNNER 3045/3035) is attached.

1 Press (Additional Functions) ➞ [Common Settings] ➞

[Cleaning Display for the Original Scanning Area].

2 Select [On] or [Off] ➞ press [OK].

Limiting Functions

If a problem frequently occurs when using the Finishing modes, such as Offset Collate and Staple, you can temporarily limit the use of these finishing modes by setting Limited Functions Mode to 'On'.

In addition, when the Service Call Message screen appears indicating a finishing mode malfunction and you temporally set the Limited Functions Mode to clear the Service Call Message screen, you can deactivate the Limited Functions Mode by setting this mode to 'Off' from the Additional Functions screen. However, after the Limited Functions Mode is deactivated, the Service Call Message screen may appear again, unless the cause of the malfunction is cleared. (See "Setting the Limited Functions Mode from the Service Call Message Screen," on p. 8-102.)

4

Customizing Settings

Specifying Common Settings

4-55