
5 | Insert the stack in the sheet feeder. |
6 | If you are loading Plain Paper, Bubble Jet Paper, or High Resolution |
Paper, make sure the paper stack is not above the load limit mark. | |
7 | Make sure the paper guide on the sheet feeder is set to the correct |
mark for the width of the media you are using. | |
8 | Check the leading edge of the stack inside the printer and make sure |
that it is square against and below the lip of the feed slot. If you see |
any sheets curling into the feed slot, remove the stack and insert it again.
|
| Incorrect | Correct |
|
|
| Yellow tab |
9 | Clean the feed rollers. (☞ 130) With long use the feed rollers may col- | ||
lect dirt and paper dust which prevent media from feeding correctly. | |||
| |||
1 | Remove the paper output receiver. | ||
2 | Remove the paper cassette. | ||
3 | If you see any paper in the paper cassette slot, remove it. | ||
4 | Press and hold down the cassette access cover on the back of the print- | ||
er. If you see any paper in the printer, remove it with your other hand | |||
| as you continue to hold open the cover. | ||
|
|
| |
|
| The spring on the cover is very strong. Hold down the rear cover | |
|
| firmly to prevent it from snapping shut quickly and pinching your | |
|
| hand. |
|
5 |
|
| |
cling.Remove the stack from the paper cassette and fan it to remove static | |||
6 | Make sure you are using the correct feed method for the media. (☞ 55) | ||
|
| Only Plain Paper, Bubble Jet Paper, and High Resolution Paper can | |
|
| be fed from the paper cassette. Other media must be fed with the | |
|
| sheet feeder or from the manual feed slot. |
Troubleshooting
Troubleshooting | 119 |