Citrix Systems CITRIX NETSCALER 9.3 manual Clearing the Configuration

Citrix NetScaler Administration Guide

Down Service Reset status : DISABLED

Nagle's Algorithm : DISABLED

Limited Persist Probes : ENABLED

Maximum out-of-order packets to queue: 64

Done

To enable SACK by using the Configuration Utility

1.In the navigation pane, expand System, and click Settings.

2.In the details pane, under Settings, click Change TCP Parameters.

3.In the Configure TCP Parameters dialog box, under TCP, select the Selective Acknowledgment check box, and then click OK.

A message appears in the status bar, stating that SACK has been configured successfully.

Clearing the Configuration

You have the following three options for clearing your NetScaler configuration.

Basic level. Clearing your configuration at the basic level clears all settings except the following:

wNSIP, MIP(s), and SNIP(s)

wNetwork settings (Default Gateway, VLAN, RHI, NTP, and DNS settings)

wHA node definitions

wFeature and mode settings

wDefault administrator password (nsroot)

Extended level. Clearing your configuration at the extended level clears all settings except the following:

wNSIP, MIP(s), and SNIP(s)

wNetwork settings (Default Gateway, VLAN, RHI, NTP, and DNS settings)

wHA node definitions

Feature and mode settings revert to their default values.

Full level. Clearing your configuration at the full level returns all settings to their factory default values. However, the NSIP and default gateway are not changed, because changing them could cause the NetScaler to lose network connectivity.

To clear a configuration by using the NetScaler command line

At the NetScaler command prompt, type the following command:

133