
Citrix NetScaler Administration Guide
2.In the details pane, do one of the following:
•To create a new trap, click Add.
•To modify an existing trap, select the trap, and then click Open.
3.In the Create SNMP Trap Destination or Configure SNMP Trap dialog box, set the following parameters:
•
•
•Destination IP
•Destination
•Source IP
•Minimum
•Community
*A required parameter
4.Click Create or OK, and then click Close.
A message appears in the status bar, stating that the trap has been configured successfully.
Enabling Unconditional SNMP Trap Logging
By default, the NetScaler appliance logs any SNMP trap messages (for SNMP alarms in which logging is enabled) when at least one trap listener is specified on the NetScaler appliance. However, you can specify that SNMP trap messages be logged even when no trap listeners are configured.
To enable or disable unconditional SNMP trap logging by using the NetScaler command line
At a NetScaler command prompt, type:
wset snmp option
wshow snmp option
Example
>set snmp option
>show snmp option
Snmpset: DISABLED | SnmpTrapLogging: |
ENABLED
Done
>
53