Citrix Systems CITRIX NETSCALER 9.3 manual 160

Chapter 6 Web Interface

•Site Path* (You cannot change the name of an existing Web interface site.)

•Site Type

•Published Resource Type

•Kiosk Mode

•

•

•

•

* A required parameter.

5.Select Direct Mode and specify values for the following parameters, which correspond to parameters described in Parameters for configuring Web interface sites on page 153 as shown:

• Virtual Server

• Protocol (select HTTPS)

• IP Address

• Port

Note:

When you create the HTTPS vserver by using the configuration utility, the configuration utility automatically creates a service, which logically represents the Web interface service running on the NetScaler appliance, and binds the service to the HTTPS virtual server.

For more information about services and virtual servers, see the Citrix NetScaler Traffic Management Guide at http://support.citrix.com/article/CTX128670.

6.Click Next.

7.On the wizard's Specify a server Certificate page, you create or specify an existing SSL certificate–key pair. The SSL certificate–key pair is automatically bound to the HTTPS vserver.

For more information, see “Binding an SSL Certificate Key Pair to the Virtual Server” in the “Secure Sockets Layer (SSL) Acceleration” chapter of the Citrix NetScaler Traffic Management Guide at http://support.citrix.com/article/ CTX128670.

8.Click Next.

9.On the wizard's Configure XenApp/XenDesktop Farm page, do one of the following:

•To add a XenApp or XenDesktop farm, click Add.

•To modify an existing XenApp or XenDesktop farm, select the farm, and then click Open.

160