Compaq Infortrend manual Deleting an ID, Setting a Primary Controller’s SCSI ID - Drive Channel

Deleting an ID

Choose the SCSI ID you wish to delete. Choose “Delete Channel SCSI ID.” The dialog box “Delete Primary/Secondary Controller SCSI ID?” will appear. Select Yes, then press [ENTER] to confirm.

IMPORTANT!

•Every time you change a channel ID, you must reset the controller for the changes to take effect.

•The default SCSI ID of the primary controller (single controller configuration) on a host channel is 0, on a Drive channel is 7.

•If only one controller exists, you must set the Secondary Controller’s ID to “NA.” If a secondary controller exists, you need to set a secondary ID on host and drive channels.

•Multiple target IDs can be applied to the Host channels while each Drive channel has only one or two IDs (in redundant mode).

•At least a controller’s ID has to present on each channel bus.

Setting a Primary Controller’s SCSI ID - Drive Channel

	Choose a drive channel,	then press [ENTER]. Choose “Primary
	Controller SCSI ID.” A list of channel IDs displays. Choose an ID.
	The dialog box “Change	Primary Controller SCSI ID?” displays.
	Select Yes, then press [ENTER].
7-27		Infortrend