Compaq Infortrend Setting Transfer Speed, Scsi Terminator Enabled CHL=0 Disable Terminator ?

Its current status will be displayed on the LCD. Press ENT to continue.

Press ENT again for two seconds to change the terminator mode to the alternate setting.

SCSI Terminator

Enabled ..

CHL=0 Disable

Terminator ?

IMPORTANT!

•You can use terminator jumpers on the controller board to control SCSI bus termination of the SentinelRAID series controllers. When using jumpers to control, firmware termination setting must be disabled. To disable SCSI termination of a SCSI bus, the associated terminator jumpers must be left open, and firmware setting must be disabled.

Setting Transfer Speed

Transfer speed refers to the SCSI bus speed in synchronous mode. Asynchronous mode is also available in this option setting. In Ultra/Ultra Wide SCSI, the maximum synchronous speed is 20.8Mhz.

Press ENT for two seconds to enter the Main Menu. Press ▼ or ▲ to select "View and Edit SCSI Channels," then press ENT.

View and Edit SCSI Channels ↕

Channel information will be displayed. Press ▼ or ▲ to select a channel. Press ENT on the channel you wish the transfer speed changed.

Press ▼ or ▲ to select “Set Transfer Speed," then press ENT.

The current speed of this SCSI channel will be displayed. Press ▼ or ▲ to select the desired speed, then press ENT for two seconds to confirm.

CH0=Host PID=0 SID=NA SXF=80.0M

Set Transfer

Speed ..

CHL=0 Clk=80.0M Change to=40.0M?

IMPORTANT!

•Every time you change the Transfer Speed, you must reset the controller for the changes to take effect.

5-29 Infortrend