Compaq Infortrend Deleting a Channel ID, Setting a SCSI Channel’s Primary ID - Drive Channel

Deleting a Channel ID

Press ENT on an existing host channel ID you want to delete. Press ▼ or ▲ to choose “Delete Channel SCSI ID," then press ENT.

Press ENT for two seconds to confirm.

Delete Channel
SCSI ID	..

Delete ID=2 Primary Ctlr ?

IMPORTANT!

•Every time you make changes to channel IDs, you must reset the controller for the configuration to take effect.

•The reserved IDs for SCSI-based controllers are shown below:

Single controller configuration (SCSI-based controllers): Drive channels – “7”

Redundant controller configuration: Drive channels – “8” and “9”

For IDs reserved in different controller configurations, please refer to the hardware manual that came with your system. For controllers connected through back-end PCBs, firmware can detect its board type and automatically apply the preset IDs. There is no need to set IDs for these models.

•In single controller mode, you should set the Secondary Controller’s ID to “NA.” If a secondary controller exists, you need to set an ID for it on each of your drive channels.

•Multiple target IDs can be applied to Host channels while each Drive channel has only one or two IDs (in redundant mode).

•At least a controller’s ID has to be present on each channel bus.

Setting a SCSI Channel’s Primary ID - Drive Channel

Press ENT for two seconds to enter the Main Menu. Press ▼ or ▲ to select "View and Edit SCSI Channels," then press ENT.

View and Edit SCSI Channels ↕

5-27 Infortrend