Compaq Infortrend manual Redundant Controller Configuration, Array Expansion, Chapter, 9.2.2

	Cylinder/Head/Sector Mapping	9-16
9.2.2	Drive-side Parameters	9-18
	SCSI Motor Spin-up	9-18
	SCSI Reset at Power-up	9-19
	Disk Access Delay Time	9-20
	SCSI I/O Timeout	9-20
	Maximum Tag Count (Tag Command Queuing)	9-21
	Detection of Drive Hot Swap Followed by Auto Rebuild	9-22
	SAF-TE and S.E.S. Enclosure Monitoring	9-22
	Periodic Drive Check Time	9-22
	Idle Drive Failure Detection	9-23
	Periodic Auto-Detect Swap Check Time	9-23
9.3	Monitoring and Safety Mechanisms	9-25
	Dynamic Switch Write-Policy	9-25
	View Peripheral Device Status (enclosure modules)	9-25
	Controller Auto-Shutdown – Event Trigger Option	9-26
9.4	Logical Drive Integrity - Disk Array Parameters	9-27
	Rebuild Priority	9-27
	Verification on Writes	9-28

Chapter 10	Redundant Controller Configuration	Page number:
		LCD/Terminal
10.3	Configuration	10-19
10.3.1	Via Front Panel Keypad	10-20
	Redundant Configuration Using Automatic Setting	10-20
	Redundant Configuration Using Manual Setting	10-21
	Starting the Redundant Controllers	10-22
	Creating Primary and Secondary IDs	10-22
	Assigning a Logical Drive/Logical Volume to the	10-23
	Secondary Controller
	Mapping a Logical Drive/Logical Volume to the Host	10-24
	LUNs
	Front Panel View of Controller Failure	10-25
	When and How is the Failed Controller Replaced	10-25
10.3.2	Via Terminal Emulation	10-26
	Redundant Configuration Using Automatic Setting	10-26
	Redundant Configuration Using Manual Setting	10-28
	Creating Primary and Secondary IDs	10-29
	Assigning a Logical Drive/Logical Volume to the	10-29
	Secondary Controller
	Mapping a Logical Drive/Logical Volume to the Host	10-31
	LUNs
	Terminal View of Controller Failure	10-32
10.3.3	When and How is the Failed Controller Replaced	10-34
	Forcing Controller Failure for Testing	10-35
	RCC status (RCC channels)	10-35
	Secondary Controller RS-232	10-35
	Remote Redundant Controller	10-35
	Cache Synchronization on Write-Through	10-35
Chapter 12	Array Expansion	Page number
12.1	RAID Expansion	12-1
12.2	Mode 1 Expansion: Adding Drive to a logical drive	12-4

xvi