Compaq Infortrend manual Index-7

Disks: terminal		SCSI target/drive	5-30
Scanning New Drive:	7-23	channel: LCD
terminal		Secondary Controller	10-16
Scanning New Drive:	5-23	Secondary Controller	8-6
LCD		ID
SCSI channel ID,	5-27	secondary controller,	7-28
deleting		setting SCSI ID/drive
SCSI channel ID,	5-26	channel
setting		secondary ID SCSI	5-28
SCSI channel primary	5-27	channel, setting
ID, setting		Serial Port	3-1
SCSI channel	5-28	serial port: connection	3-1, 3-6
secondary ID, setting		and setup
SCSI channel	5-28	Setting a New	7-35
terminator		Password: terminal
SCSI channel	7-28	Setting a Primary	7-27
terminator		Controller’s SCSI ID:
SCSI channel,	9-11	terminal
explained		Setting a channel’s ID:	5-26
SCSI Channel’s Status:	6-7	LCD
terminal		Setting a channel’s	5-27
SCSI channels, viewing	7-25	Primary ID: LCD
and editing		Setting a channel’s	5-28
SCSI commands,	5-22, 7-21	Secondary ID: LCD
pass-through		Setting a SCSI	5-28
SCSI Drive Information:	7-42	channel’s Terminator:
terminal		LCD
SCSI Drive Low-level	5-40	Setting Transfer	5-29
Format: LCD		Speed: LCD
SCSI Drive Low-level	7-43	Setting Transfer Width:	5-30
Format: terminal		LCD
SCSI Drive Read/Write	5-41	Shutdown Controller:	5-35
Test: LCD		LCD
SCSI Drive Read/Write	7-44	Single drive control	1-3
Test: terminal		Slot number: LCD	5-31
SCSI Drive Status:	4-4	Spanning	1-3
LCD		Spare drive	2-4
SCSI Drive Utilities:	5-40	Spare Drive	5-7~8
LCD		Assignments: LCD
SCSI Drive Utilities:	7-42	Spare Drives	1-6, 1-11, 1-
terminal			14
SCSI Drive’s Status:	6-6	Spin-Up Parameters	2-10
terminal	7-22	Stripe size	B-1
SCSI drives, viewing		Striping	1-4
and editing
		Sun Solaris	9-16
SCSI I/O Timeout	9-20
		configuration
SCSI ID, deleting	7-27
		Synchronized cache	B-6
SCSI Motor Spin-Up	9-18
		System Functions: LCD	5-34
SCSI Parameters	2-10
SCSI Reset at Power-	9-19	T
Up	5-30
SCSI target/drive
channel, viewing and		Tag Command Queue	B-3
editing

Index-7