Setup WPA Enterprise for Access Point
(Available in Access Point, Repeater and Gateway Modes)
Follow these steps if you have selected the
At the WPA1/2-Enterprise AP Setup page,
Step 1:
Key in the IP address of the Primary RADIUS Server in your WLAN.
You can optionally add in the IP address of a Secondary RADIUS Server, if any. The RADIUS authentication server MUST be in the same subnet as the access point.
Step 2:
By default, the value for Authentication Port number is 1812. You can either leave this value as it is or key in a different Authentication Port but it MUST match the corresponding port of the RADIUS server.
Step 3:
By default, the value for Accounting Port is 1813. You can leave this value as it is. This value must be set to be the same as the one in the RADIUS server.
Step 4:
Enter the Shared Secret Key used to validate
Step 5:
Enter the GTK (Group Transient Key) Updates.
This is the length of time after which the access point will automatically generate a new shared key to secure multicast/broadcast traffic among all stations that are communicating with it. By default, the value is 600 seconds.
Step 6:
Click the Apply button and reboot your system, after which your settings will become effective.
Page 135
