Channel
SYNTAX | DESCRIPTION |
Set channel <value> | (Value in decimal) |
SSID |
|
SYNTAX | DESCRIPTION |
Set ssid <string> | (Not More than 32 characters) |
Closed System |
|
SYNTAX | DESCRIPTION |
Set hidessid enable/disable | Enable or disable broadcasting of SSID. |
Per Node |
|
SYNTAX | DESCRIPTION |
Set apbridge enable/disable | Enable or disable isolation of wireless client. |
RTS, Fragment, and Beacon Interval | |
SYNTAX | DESCRIPTION |
Set rts <value | (Value in decimal, default 2312, range 1 to 2312) |
Set fragment <value> | (Value in decimal, default 2346, range, 256 to 2346) |
Set beaconintval <value> | (Value in decimal, default 1, range 1 to 1000) |
Set dtim <value> | Data Beacon Rate (value in decimal, default 1, range 1 to 16384) |
WLAN State |
|
SYNTAX | DESCRIPTION |
Get wlanstate | Display whether status of current wireless operation is Enabled or Disabled. |
Set wlanstate enable/disable | Set to Disable to turn off wireless operation. |
| Set to Enable to turn back on wireless operation. |
| Note: |
| When executing this command, please ensure that you are not connected on |
| wireless with device or you will be disconnected from the device and network. |
| The wireless operation can only be Enabled from the Ethernet port or UTP cable |
| connection to device. |
Reset Button |
|
SYNTAX | DESCRIPTION |
Get buttonpassreset | Display the status of Reset Button operation. |
| If status is (Enabled), resetting of password by pressing Reset Button is allowed. |
| If status is (Disabled), resetting of password by pressing Reset Button is not allowed. |
Set buttonpassreset enable/disable | Set to Disable to prevent resetting of password by pressing Reset button. |
| Set to Enable to allow resetting of password by pressing Reset button. |
Upgrade Firmware |
|
SYNTAX | Set upgrade <IP address of AP> <firmware image filename> |
DESCRIPTION | To upgrade firmware in CLI enter this command with the IP address of AP and the |
| firmware image filename. |
Page 170
