Appendix: Use the Command Line
Interface
Get Operation List
SYNTAX | DESCRIPTION |
Get tasks | Display all active process/tasks. |
Get sysinfo | Display system information. |
Get aplist | Display list of access points discovered. |
Get athstats | Display wireless driver information. |
Get brinfo | Display bridge and interfaces information. |
Get brmacshow | Display bridge learned MAC address list. |
Get bssinfo. | Display current radio information. |
Get channel | Display current wireless channel number. |
Get chanlist | Display current domain wireless channels. |
Get ieee80211stats | Display ieee80211 protocol statistics. |
Get routeshow | Display the routing table information. |
Get stalist | Display a list of currently associated stations. |
Get linkinfo | Display client link information (Client mode only) |
Get macstats | Display a list of currently learnt wireless device MAC addresses. |
Get opmode | Display current wireless operation mode. |
Get wmode | Display wireless mode |
Set Operation List |
|
SYNTAX | DESCRIPTION |
Set factorydefault | Set factorydefault – restore configuration to factory default. |
Restart | Do a warm reboot. |
Save Configuration |
|
SYNTAX | DESCRIPTION |
Commit | Save current configuration to flash. |
| Most commands require rebooting to take effect after saving. |
Long Range
Check for recommended values from long distance option setup page.
SYNTAX | DESCRIPTION |
Set outdoor <enable/disable> | Enable outdoor for |
Set distance <value> | Set the connection distant (value in decimal) |
Set acktimeout <value> | Set the ACK timeout (value in decimal) |
Set ctstimeout <value> | Set the CTS timeout (value in decimal) |
Set slottimeout <value> | Set the Slot timeout (value in decimal) |
TX Power |
|
SYNTAX | DESCRIPTION |
Set txpower <string> | (Default full) auto, 1, 2, 3, 4, ..., 17, full, min |
TX Rate |
|
SYNTAX | DESCRIPTION |
Set txrate <string> | Values are: (default auto) |
| |
| (802.11b/g |
|
Page 167
