Enterasys Networks Network Card manual Do one of the following, 113

Chapter 5 Adding Corporate ISPs

Controlling Remote User Dialing & Access

23Choose the dial-up protocols supported by the ISP from the Frame Protocols menu.

Nearly all ISPs and dial-up Remote Access Service (RAS) servers support the default Point-to-Point Protocol (PPP). If the dial-up server at the ISP supports other protocols, such as Serial Line Interface Protocol (SLIP), you may choose another protocol from the menu.

24Select the Network Protocols to use over the dial-up connection as follows:

–To enable TCP/IP protocol over the dial-up connection, place a check next to TCP/IP. This protocol is required for Internet access.

–To enable Microsoft’s NetBEUI protocol over the dial-up connection, please a check next to NetBEUI. NetBEUI provides fast network browsing in small networks that are primarily Microsoft-based.

–To enable IPX and SPX protocols over the dial-up connection, place a check next to IPX/SPX. These protocols are normally required for access to Novell NetWare servers.

NOTE

NetBEUI is not a routable protocol. You should select at least one other protocol to allow packets to be routed through the Internet or corporate network.

25Do one of the following:

–Click Update to save the new ISP information.

–Click Cancel to clear the ISP information without saving your changes.

RiverMaster Administrator’s Guide 113