Enterasys Networks Network Card manual 237

Appendix B Configuring Routing Interfaces

ANG-3000/7000 Preconfiguration Stored on a Floppy Disk

These values are used to authenticate RIP updates from routers on the network

Figure 135 Routing Interfaces Configuration - RIP

2In the RIP Authentication fields, choose the algorithm (simple or none) used by routers on your network.

If the routers on your network do not require passwords to accept RIP updates, set the algorithm to None and skip to Step 6.

NOTE

RIP update authentication is only supported by RIP Version 2. If the routers on your network only support RIP Version 1, you cannot enter values in the RIP Authentication fields.

3Type the RIP authentication password used by routers on your network in the Password field.

RIP authentication passwords are used by routers to determine if they should accept updated routing information sent from another router. If your routers do not authenticate updates, leave this field blank and skip to Step 6.

4Type the same password in the Re-Type Password field exactly as you entered it in Step 3.

RiverMaster Administrator’s Guide 237