Chapter 3

Routing

Configuring an ANG-3000/7000

6Select the interface (Trusted or External) from the list under Network Interfaces.

The protocols already enabled for this interface appear in the Routing

Protocols list.

7Do one of the following:

To add a protocol to the trusted interface, click Add and continue with the next step.

To remove a protocol, select the protocol from the Routing Protocols list and click Remove. Skip to Step 10.

8When the Add an Interface Routing Protocol window appears as shown in Figure 35, select a routing protocol and click Add.

Figure 35 Adding a Routing Protocol

NOTE

For the External interface, you can only add or remove static routing. Because the External interface is optimized for tunnel protocols only, you cannot use RIP or OSPF on this interface.

9Do one of the following:

If you are adding RIP to the interface, perform the steps in “Configuring RIP for the Interface” on page 62.

If you are adding OSPF to the interface, perform the steps in “Configuring OSPF on an Interface” on page 64.

If you are adding a static route to the interface, perform the steps in “Creating Static Routes” on page 65.

10Do one of the following:

Click Apply to save the routing protocol configuration changes.

Click Reset to the return the interface’s protocol configuration to its original setting.

RiverMaster Administrator’s Guide

61

Page 73
Image 73
Enterasys Networks Network Card manual Adding a Routing Protocol