Enterasys Networks Network Card manual Appendix B, 240

Configuring Routing Interfaces Appendix B

ANG-3000/7000 Preconfiguration Stored on a Floppy Disk

NOTE

If you use static routes, the ANG will not broadcast IP pools. You must add a static route on your internal router for that subnet. The internal IP address of the ANG is the gateway.

To configure a static route between a Aurorean Network Gateway interface and another device, perform the following steps:

1In the Routing Configuration window, with the Interfaces tab selected, choose the ANG Ethernet interface to configure (External or Trusted) and click Add.

2In the Routing Protocol selection list of the Add an Interface Route Protocol popup window, double click Static Routes and click Add in the Static Route Configuration window.

The Static parameter tab page is displayed as shown in Figure 137.

Figure 137 Static Routing Configuration Window

240 RiverMaster Administrator’s Guide