Enterasys Networks Network Card manual Click Add, 229

Appendix B Configuring Virtual Subnets

ANG-3000/7000 Preconfiguration Stored on a Floppy Disk

1Click Add.

The Add an IP Virtual Subnet popup window appears as shown in Figure 128.

Figure 128 Add an IP Virtual Subnet Popup Window

2Enter the starting address of the subnet in the Address fields.

You can use actual IP addresses from your network or non-routable IP address ranges (such as 192.168.x.x for a Class C network).

3Enter a subnet mask to define the subnet range in the Mask field.

4Do one of the following:

–Click Add to add the new virtual subnet.

–Click Cancel to close the window without saving your changes.

5Repeat previous steps for each virtual subnet you require.

6Click Add to save your changes and Next to bring up the Routing Configuration window as shown in Figure 129.

To return the parameters to their original settings without saving your changes, click Reset.

RiverMaster Administrator’s Guide 229