Chapter 3

Routing

Configuring an ANG-3000/7000

NOTE

RIP update authentication is only supported by RIP Version 2. If the routers on your network only support RIP Version 1, you cannot enter values in the RIP Authentication fields. Refer to “Configuring RIP for the Interface” on page 62 for instructions on selecting the version of RIP used on your network.

4Type the RIP authentication password used by routers on your network in the Password field.

RIP authentication passwords are used by routers to determine if they should accept updated routing information sent from another router. If your routers do not authenticate updates, leave this field blank and skip to Step 2.

5Type the same password in the Re-Type Password field exactly as you entered it in Step 4.

6Set the RIP Route Importing/Exporting options as follows:

To allow the ANG interface to learn new routes, place a check next to Enable Import. If you enabled the Intelligent Client Routing feature, you should turn on Enable Import to allow the ANG to pass known reachable addresses to the remote client.

To cause the ANG to advertise its known routes, place a check next to Enable Export. This setting is required to allow the ANG to advertise the reachability of virtual subnets to other devices on the network.

7Do one of the following:

Click Apply to save the RIP configuration changes.

Click Cancel to close the window without saving your changes.

Click Reset to the return the interface’s protocol configuration to its original setting.

RiverMaster Administrator’s Guide

63

Page 75
Image 75
Enterasys Networks Network Card manual Do one of the following