Enterasys Networks Network Card manual Add Remote ANG Window, 219

Appendix B Adding Remote Gateways

ANG-3000/7000 Preconfiguration Stored on a Floppy Disk

Figure 121 Add Remote ANG Window

NOTE

Unless you are configuring a tunnel from the ANG/APS pair to a Remote ANG, you only need to enter the Remote Gateway Name and IP Address.

4Enter a Remote Gateway Name and IP address in the fields provided.

5Type a User Name, User Password and confirm the password.

This User Name and Password must also be registered in the authentication database in the ANG at the remote site by adding the user to a group (Refer to Chapter 6 for more information).

6Choose the tunneling protocol: IPSec or PPTP.

7Click Add.

The Remote ANG is added to the configuration on your local ANG. A message displays stating the Remote ANG was successfully added. Because the preceding configuration information is not immediately written to a floppy disk, we strongly recommend you repeat this procedure for all Remote ANGs you plan to add.

RiverMaster Administrator’s Guide 219