Enterasys Networks Network Card manual Setting Trace Levels, ANG Tunnel Management Service Window

Chapter 4 Setting Trace Levels

Setting Up Aurorean Services

Setting Trace Levels

To set the trace level for any of the ten services, perform the following steps:

1 Open the Configuration pullout.

2Click on the Activity icon in the lower left corner of the pullout to view the Active Service List.

Figure 53 shows the Tunnel Management Service window with the full Active Service List displayed.

3Expand the tree list under Active Service List (click the + symbol).

4Select the service of your choice.

	Click to open the
Set the Trace Level here	Configuration pullout

Click here to expand the tree list

Select the	Click here to
service	configure the
	trace level

Click here to view the list of services Start or stop the trace service by clicking here

Figure 53 ANG Tunnel Management Service Window

RiverMaster Administrator’s Guide 97