Enterasys Networks Network Card manual Remote Tunnel Properties window appears as shown in Figure

Adding a Remote Server	Chapter 3
	Configuring an ANG-3000/7000

To change properties for the Remote Tunnel, perform the following steps:

1Select your Remote Tunnel from the tree list under Remote Servers and click Properties in the display.

The Remote Tunnel Properties window appears as shown in Figure 42.

Click here to update the tunnel

Click here to refresh the values for the Current state and Last try result attributes shown in the Tunnel Protocols window

Figure 42 Remote Tunnel Properties Window

2Change any information. If the Remote Tunnel is enabled, select Disabled in the Enabled State field and do one of the following:

–Click Update to reconfigure the Remote Tunnel.

–Click Cancel to close the window without saving your changes.

–Click Delete to remove the Remote Tunnel configuration.

If you clicked Update, a window pops up asking if you want to save the modified tunnel. Click Yes or No.

72 RiverMaster Administrator’s Guide