Enterasys Networks Network Card manual Configuring RIP for the Interface, 236

Configuring Routing Interfaces Appendix B

ANG-3000/7000 Preconfiguration Stored on a Floppy Disk

Figure 134 Adding a Routing Protocol

NOTE

For the External interface, you can only add or remove static routing. Because the External interface is optimized for tunnel protocols only, you cannot use RIP or OSPF on this interface.

5Do one of the following:

–If you are adding RIP to the interface, perform the steps in “Configuring RIP for the Interface” on page 236.

–If you are adding OSPF to the interface, perform the steps in “Configuring OSPF on an Interface” on page 238.

–If you are adding a static route to the interface, perform the steps in “Creating Static Routes” on page 239.

Configuring RIP for the Interface

To configure RIP on an interface, continue floppy disk configuration with the following steps:

1In the RIP Interface window, shown in Figure 135, choose the version of RIP to use on this interface.

RIP Version 1 uses IP broadcast packets for periodic announcements of reachable subnets. RIP Version 2 is an enhanced version of RIP that uses IP multicast packets for announcements.

236 RiverMaster Administrator’s Guide