Chapter 3

Adding a Remote Server

Configuring an ANG-3000/7000

12Click the arrow in the Remote Server Name field to bring up a pull- down list and select the Remote Server you just added.

RiverMaster types the Server user name and password into the open fields. You may change these settings if necessary.

13Select Enabled or Disabled in the Enabled State field.

If you select Enabled, the tunnel will be created immediately. Select Disabled if you want to delay enabling the tunnel until configuration is complete at the other end of the tunnel.

14Click Add.

If the Enabled state was selected earlier, the tunnel becomes operational in a few moments.

NOTE

You can configure additional tunnels to the Remote Server just added by selecting the particular server in the Remote Tunnels display, clicking Properties, and clicking Add Tunnel in the Remote Server Properties window.

Changing Server and Tunnel Properties

The information configured for Site-to-Site servers and tunnels can be changed by clicking the Properties buttons on either display.

To change properties for the Remote Server, perform the following steps:

1 Select your Remote Server from the tree list under Remote Servers and click Properties in the display.

2When the Remote Server Properties window appears, change any information and do one of the following:

Click Modify to reconfigure the Remote Server.

Click Cancel to close the window without saving your changes.

Click Delete to remove the Remote Server configuration.

RiverMaster Administrator’s Guide

71

Page 83
Image 83
Enterasys Networks Network Card manual Changing Server and Tunnel Properties