Enterasys Networks Network Card manual RIP Routing Protocol Configuration

Routing	Chapter 3
	Configuring an ANG-3000/7000

If this list is blank, the Aurorean Network Gateway accepts RIP updates from all routers on the subnet. You can limit the amount of updates that the Aurorean Network Gateway will accept by specifying individual routers in this list.

Figure 31 RIP Routing Protocol Configuration

2To turn on RIP for IPX packets, click Enable under IPX RIP Enable; otherwise, continue with the next step.

3Do one of the following:

–To allow the ANG to accept RIP updates from all routers on the same subnet, no further work is required. Skip to Step 6.

–To configure “trusted” individual routers to supply RIP updates to the ANG, click Add and continue with the next step.

The Add A Trusted Gateway window appears as shown in Figure 32.

Figure 32 Adding A Trusted Gateway for RIP

4In the Address field, type the address for the router that the ANG will accept updates from and click Add.

You can later modify this address or delete it using the Modify and

Remove buttons.

56 RiverMaster Administrator’s Guide