Enterasys Networks Network Card manual Adding a Remote Server, Remote Server Display

Adding a Remote Server Chapter 3

Configuring an ANG-3000/7000

Adding a Remote Server

An ANG can be added at a remote location in a Site-to-Site configuration. This section describes how to set up an initiating Network Gateway to connect to a Local or terminating ANG/APS pair.

NOTE

Local ANGs use an accompanying APS; remote ANGs are stand-alone.

These instructions cannot be used to configure a stand-alone ANG connection to another stand-alone ANG (refer to Appendix B for more information).

To add a Remote Network Gateway, perform the following steps.

1Open the Configuration pullout.

2In the list of Aurorean devices, expand the tree list under gateways (click the + symbol).

3Expand the tree list under Remote Servers.

The Tunnel Protocols window appears as shown in Figure 39.

Click here to expand the tree list

Click here to add the Remote Gateway or Tunnel

Click here to select the

created server or tunnel

Click here to
access the
Network Gateway	Click here to display the configured properties	of the selected device
configuration
windows	Figure 39 Remote Server Display

Click here to open the Configuration pullout

68 RiverMaster Administrator’s Guide