Configuring Tunnel Protocols

Appendix B

 

ANG-3000/7000 Preconfiguration Stored on a Floppy Disk

For each tunnel protocol, you can configure authentication, encryption, and compression parameters. To set tunnel protocol parameters, continue floppy disk configuration with the following steps.

Figure 123 General Tab of Tunnel Protocols Window

1If you want to prevent the Remote Gateway from using one of the tunnel protocols, select the protocol and click Remove.

By default, PPTP and IPSec are both enabled. You normally control protocol usage on a per group basis by selecting the protocol when you assign group policies (refer to Chapter 6 of the RiverMaster Administrator’s Guide for instructions). If you want to globally disable a protocol, you can remove it from this list. If you have removed a protocol and want to reinstall it, click Add once and when the highlighted tunnel protocol pops up, click Add again. You are not required to click Apply.

222

RiverMaster Administrator’s Guide

Page 234
Image 234
Enterasys Networks Network Card manual Configuring Tunnel Protocols, 222