Enterasys Networks Network Card manual Ospf Properties, 232

Configuring Routing Protocols	Appendix B
	ANG-3000/7000 Preconfiguration Stored on a Floppy Disk

3Do one of the following:

–To allow the Aurorean Network Gateway to accept RIP updates from all routers on the same subnet, no further work is required. Skip to “OSPF Properties”.

–To configure “trusted” individual routers to supply RIP updates to the Aurorean Network Gateway, click Add and continue with the next step.

The Add A Trusted Gateway window appears as shown in

Figure 131.

Figure 131 Adding A Trusted Gateway for RIP

4In the Address field, type the address for the router that the Aurorean Network Gateway will accept updates from and click Add.

You can later modify this address or delete it using the Modify and Remove buttons.

5Repeat Step 3 and Step 4 for each gateway required.

6Do one of the following:

–Click Apply to save your changes and Cancel to close the window. If you want to configure OSPF on the ANG, continue with the next section, otherwise skip to “Configuring Routing Interfaces.”

–Click Cancel to close the window without saving your changes.

–Click Reset to return the RIP parameters to their default settings.

OSPF Properties

To enable OSPF on an interface, continue floppy disk configuration with the following steps:

1With the OSPF Configuration window displayed as shown in Figure 132, type the area ID shared by the Aurorean Network Gateway and routers within the subnet in the OSPF Area ID fields.

232 RiverMaster Administrator’s Guide