Enterasys Networks Network Card manual Configuring Ospf on an Interface, 238

Configuring Routing Interfaces Appendix B

ANG-3000/7000 Preconfiguration Stored on a Floppy Disk

5Set the RIP Route Importing/Exporting options as follows:

–To allow the Aurorean Network Gateway interface to learn new routes, place a check next to Enable Import. If you enabled the Intelligent Client Routing feature, you should turn on Enable Import to allow the ANG to pass known reachable addresses to the remote client.

–To cause the ANG to advertise its known routes, place a check next to Enable Export. This setting is required to allow the ANG to advertise the reachability of virtual subnets to other devices on the network.

6Do one of the following:

–Click Apply to save the RIP configuration changes, click Cancel to close the window, and click Next to continue configuration.

–Click Cancel to close the window without saving your changes.

–Click Reset to the return the interface’s protocol configuration to its original setting.

Configuring OSPF on an Interface

To enable OSPF on an interface, perform the following steps:

1In the OSPF Interface window, shown in Figure 136, Type the OSPF password used by routers on your network in the Authentication Password field.

OSPF authentication passwords are used by routers to determine if they should accept updated routing information sent from another router. If your routers do not authenticate updates, leave this field blank.

NOTE

Passwords are limited to 8 characters or less.

238 RiverMaster Administrator’s Guide