Extron electronic DVS 510 SA manual Configuring the audio

2.In the Input Selection section, click the desired input button.

The button on the screen is highlighted and its equivalent button on the front panel lights as follows, depending on your signal type selection:

•If you selected Both as the signal type, the input button on the screen is highlighted and the equivalent front panel button lights amber.

•If you selected either Audio or Video (audio or video breakaway), the following occurs:

•Video: The screen input button is highlighted and the equivalent front panel button lights green.

•Audio: The screen input button is highlighted and blinks (the blinking continues until the audio is switched to a different input). The equivalent button on the front panel lights red.

3.If using audio or video breakaway, repeat steps 1 and 2 for the remaining signal type.

Configuring the audio

In the Audio section, you can configure the audio signal by adjusting the following controls:

•Mute: Click this button to mute and unmute the audio. When audio is muted, this button is highlighted. The default is unmuted.

•Delay: Click this button to delay the audio to match the video delay. When audio delay is enabled, this button is highlighted (the default).

•Volume: Raise or lower the volume level by selecting a volume step (1 through 100) from the drop-down menu or by clicking the + or – buttons to increase or decrease the step number.

•Gain/Attenuation: Set the gain level by selecting a + number from the drop-down menu or the attenuation level by selecting a – number. Alternatively, click the + and – buttons to increase or decrease the gain or attenuation level. The default is 0.

•Bass: Increase or decrease the bass by selecting a level (-12through +12) from the drop-down menu or by clicking the + or – buttons to increase or decrease the level. The default is 0.

•Treble: Increase or decrease the treble by selecting a level (-12through +12) from the drop-down menu or by clicking the + or – buttons to increase or decrease the level. The default is 0.

•Output format: Click the Mono (for dual mono) or Stereo button to select the output type. The selected button is highlighted. The default is Stereo.

•Audio Start Up Limiter: (DVS 510 SA only) From the drop-down menu, select the maximum volume level that the limiter will permit when the DVS is powered up. You can select volume step 1 through 100.

DVS 510 Series • HTML Configuration and Control 100