Extron electronic DVS 510 SA manual Locking IR Remote Control Access

Locking IR Remote Control Access

The DVS can be set to lock out users from using the IR 904 Remote Control to control the scaler. Remote access can be enabled and disabled via SIS commands (see the

IR Receiver commands on page 65 in the Command and Response Table for SIS Commands). When remote access is locked, all other controls remain available (SIS commands, web pages, control software, and front panel).

NOTES: • By default, the IR receiver is disabled.

• The DVS must be connected to power before you operate the remote control. Setup operations cannot be performed from the remote control.

Installing Batteries in the IR 904 Remote Control

Install two AAA batteries in the IR 904 Remote Control as shown below.

Figure 25. Installing Batteries in the IR 904 Remote Control

Buttons on the IR 904 Remote Control

The following DVS 510 Series functions are available through the buttons on the IR 904 IR Remote Control:

1

			PIP
			ON/OFF	VOLUME
			SWAP
		INPUT SELECTION
1		2	3		4
5		6	7		8
9		10			AUTO
					IMAGE
A/V		SIZE		POSITION
MUTE
9
VIDEO
MUTE
8			ADJUST
AUDIO	ZOOM				PAN
MUTE
7
-	IMAGE ADJUSTMENTS				+
	COLOR	+	-	TINT
-	CONT	+	-	BRIGHT	+
-	DETAIL	+			FREEZE

IR 904

REMOTE

2

3

4

5

6

Figure 26. Buttons on the IR 904 Remote Control

DVS 510 Series • Operation 44