Extron electronic DVS 510 SA Film Mode Detect, Vertical Start Position, Horizontal Start Position

Input Configuration Submenu	Horizontal ([) and Vertical Knob ({) Adjustment
Video Signal Type (Inputs 5, 6, 7, and 9)	Select the desired video format for the selected input
Accepted video signal types include RGB, RGBcvS,	(this adjustment is available only for inputs 5, 6, 7, and
	9). The default is RGB.
YUVp/HDTV, and YUVi.
Film Mode Detect	Select On or Off to turn 3:2 or 2:2 pulldown (film mode)
Enable and disable 3:2 pulldown detection for NTSC and	detection on and off for the selected input. The default
2:2 film detection for PAL video sources.	is Off.
3:2 and 2:2 pulldown (film modes) help maximize image
detail and sharpness for video sources that originated
from film. When film is converted to NTSC video, the
film frame rate must be matched to the video frame
rate. “Jaggies” and other image artifacts can result if
conventional de-interlacing techniques are used on film-
source video.
When film mode is enabled, the DVS recognizes
signals that originated from film and then applies video
processing algorithms that optimize the conversion
of video that was made with the 3:2 or 2:2 pulldown
process. This results in sharply detailed images.
Vertical Start Position	Select the vertical start position. The default is 128.
The distance in pixels from the top edge of the total
video display area for the selected input to the top edge
of its active area
Horizontal Start Position	Select the horizontal start position. The default is 128.
The distance in pixels from the left edge of the total
video display area for the selected input to the left edge
of its active area
Pixel Phase (Inputs 5, 6, 7, and 9)	Select the amount to move the pixel sampling point
The point at which pixels are sampled (available only for	to ensure output clarity. The range of settings is 0-31;
	default is 16.
RGB and YUVp/HDTV inputs)
Total Pixels (Inputs 5, 6, 7, and 9)	Select the width in pixels of the total video display area
The width in pixels of the total video display area	for the selected input. The default width is marked with
	an asterisk (*) on the LCD screen.
(available only for RGB and YUVp/HDTV inputs)
Active Pixels	Select the width in pixels of the active video area for
The width in pixels of the active video area	the selected input. The default width is marked with an
	asterisk (*) on the LCD screen.
Active Lines	Select the height in lines of the active video area of the
The height in lines of the active video area	selected input. The default width is marked with an
	asterisk (*) on the LCD screen.
EDID (Extended Display Identification Data)	Select an EDID to apply to the selected input.
(Inputs 5, 6, 8, and 10)	• The Horizontal ([) Adjust knob selects the
The resolution and refresh rate of a display device
	resolution.
(available only for RGB and DVI inputs)
	• The Vertical ({) Adjust knob selects the refresh rate.
NOTE: This submenu is not displayed when
input 1-4, 7, or 9 is selected.

DVS 510 Series • Operation 25