Wiring the Amplified Audio Port (DVS 510 SA Only)

To connect speakers to the DVS 510 SA built-in amplifier, terminate the speaker cable as follows:

1.Strip the end of the cable 3/16 inches (5 mm).

CAUTIONS: The length of the exposed wires in the stripping process is critical. The ideal length is 3/16 inches (5 mm). If the exposed portion is longer, the wires may touch, causing a short circuit between them. If the exposed wires are shorter, they can be easily pulled out, even if tightly fastened by the captive screws.

Do not tin the wires. Tinned wire does not hold its shape and can become loose over time.

2.Secure the wires into the supplied 4-pole captive screw connector.

CAUTION: Do not short the + and - outputs to each other because this will damage the amplifier.

The following table shows which speaker wires to connect to the positive and negative pins of the Amplified output connector.

Speaker Wire Color

To Amplified Connector Pins (Left and Right)

Red

Black

Positive (+)

Negative (-)

Speaker 1

Speaker 2

Audio Output

to Speakers

4-pole Captive

Screw Connector

AMPLIFIED

 

4/8

 

Ohms

L

R

Figure 9. Wiring Speakers to the Amplified Connector on the DVS 510 SA

NOTE: Be sure to observe the correct speaker impedance loading when setting up a

speaker system. (See figure 10 on the next page for examples.)

DVS 510 Series • Installation 12

Page 18
Image 18
Extron electronic manual Wiring the Amplified Audio Port DVS 510 SA Only, Red Black Positive + Negative