Extron electronic DVS 510 SA manual Input Configuration Menu, Composite, Video

Input Configuration Menu

The Input Configuration menu allows you to select a video signal type for the configurable inputs: 5, 6, 7, and 9. (Inputs 1 and 2 are composite video only, inputs 3 and 4 are S-video only, and inputs 8 and 10 are DVI only.) The table below summarizes the available signal types for each input.

Input 1	Input 2	Input 3	Input 4	Input 5	Input 6	Input 7	Input 8	Input 9	Input 10
Composite	Composite	S-video	S-video	RGB*	RGB*	RGB*	DVI	RGB*	DVI
				YUVp/	YUVp/	YUVp/		YUVp/
				HDTV	HDTV	HDTV		HDTV
				RGBcvS	RGBcvS	RGBcvS		RGBcvS
				YUVi	YUVi	YUVi		YUVi
*Default

You can also enable and disable film detection; select the horizontal and vertical start positions, pixel sampling phase, total pixels, active pixels, active lines; and select an EDID (extended display identification data) for an input. Rotate the horizontal ([) or the vertical ({) Adjust knob to adjust the settings.

The following flowchart provides an overview of the Input Configuration menu and submenus and the options for each setting.

User

Presets

Menu

Input

Configuration

Next

Input # 5		Next	Input # 5	Next	Input # 5
	RGB		Film Detect: Off		Vert Start: 128

Next

Input # 5

Horz Start: 128

Next

Input # 5

Pixel Phase: 16

Input video type		Film Detect
For inputs 5, 6, 7, and 9,		Turn Film Detection on
select an available signal		or off.
format:
•	RGB (Default)
•	YUVp/HDTV
•	RGBcvS
•	YUVi

Vertical Start Select a vertical start line position for the top edge of the active video.

Horizontal Start Select a horizontal start pixel position for the left edge of the active video.

Pixel Phase

Adjust the pixel sampling point.

Next

Next

Input # 5	EDID	Next	Input # 5	Next	Input # 5	Next	Input # 5
1280x1024	60 Hz		Active Lns: 1080		Active Pix: 1920		Total Pix: 2750

Resolution

Select the input resolution:

•Match Output (Default)

•See the Resolution and Refresh Rate table in the “Output Configuration Menu” section for a complete list of available resolutions.

Refresh Rate

Select the rate:

•50 Hz

•59.9 Hz

•60 Hz

•75 Hz

Active Lines

Specify the height in lines of the active image area to be sampled.

Active Pixels

Specify the width in pixels of the active image area to be sampled.

Total Pixels

Specify the width in pixels of the total image area to be sampled.

Figure 15. Input Configuration Menu

DVS 510 Series • Operation 23