Extron electronic DVS 510 SA manual Creating Labels Using the Button Label Generator

3.Locate the small corner notch on the lens cap, and slide the screwdriver between the lens cap and the diffuser (see B in the illustration below).

4.Using a rotating motion of the screwdriver, carefully pry the two pieces apart (see C in the illustration below).

5.Lift out the transparent square label that you want to replace. You may need to use the small screwdriver to gently pry the label out.

6.Insert one of the new labels you created in step 1 into the clear button cap, align the white backing plate with the cap, and firmly snap it into place.

7.Gently, but firmly, press the reassembled button into its space on the DVS front panel, until it snaps into place.

8.Repeat steps 1 through 7 as needed to relabel other buttons.

Plunger

Base

Clear Lens	3	Diffuser
		Button Label
2	Pry the two
	pieces apart.
	Notch

Separating the two- piece button here at the corner.

Figure 53. Replacing a Button Label

Creating Labels Using the Button Label Generator

The Button Label Generator software creates labels that you can place inside the transparent covers of the front panel buttons. You can create labels with names, alphanumeric characters, icons, and even colored bitmaps for easy and intuitive input and output selection. (See “Replacing Button Labels” on the previous page for procedures for removing and replacing the button covers.)

The program is contained on the same DVD as the Signal Processing Products Control Program, and is installed automatically when you install the control software. By default, the software installation creates a directory for the program at C:\Program Files\Extron\ButtonLabelGenerator. The Button Label Generator icon is placed in the Extron Electronics group or folder.

1.To run the label creation program, double-click on the Button Label Generator icon (shown at right) in the Extron Electronics group or folder. The Button Label Generator window opens.

DVS 510 Series • Reference Information 113