Extron electronic DVS 510 SA manual DVIIM-VGAF/DVIIF DVI and Analog Breakout Cable

EVideo inputs 7/8 and 9/10 — Connect two DVI, two RGB/YUV, or one each video sources to these DVI-I connectors. The analog portions of these connectors are identified as inputs 7 and 9, while the DVI portions are recognized as inputs 8 and 10. These connectors feature EDID emulation.

The following tables show the DVI-I connector pin assignments for DVI and analog source connection.

Digital Connections Analog Connections

Pin	Signal	Pin		Signal	Pin	Signal
1	TMDS data 2–	9	TMDS data 1–		17	TMDS data 0–
2	TMDS data 2+	10	TMDS data 1+		18	TMDS data 0+
3	TMDS data	11	TMDS data 1/3		19	TMDS data 0/5
	2/4 shield		shield			shield
4	Not used	12	Not used		20	Not used
5	Not used	13	Not used		21	Not used
6	DDC clock	14	+5 V power		22	TMDS clock
						shield
7	DDC data	15	Ground		23	TMDS clock+
8	Not used	16	Hot plug		24	TMDS clock–
			detect
		1	8

Pin		Function
C1	Red signal
C2	Green signal
C3	Blue signal
C4	Horizontal sync
C5	Ground
	C1		C2
	C5
	C3		C4

9 17 24

Breakaway cable: You can use an optional Extron DVIIM-VGAF/DVIIF “Y” DVI adapter cable (shown below) to connect one analog RGB or YUV source and one DVI source to one or both of these connectors. This cable enables both an analog and a DVI source device to be connected to these ports and active at the same time.

DVI-I Male Connector

To DVS 510 Female DVI-I Input Connector (Input 7/8 or 9/10)

DVI-I Female Connector

FOR DIGITAL ONLY

To a DVI

Input Source

Extron	To an RGB or YUV
	Analog Input Source

15-pin HD

Female Connector

FOR ANALOG ONLY

Figure 3. DVIIM-VGAF/DVIIF DVI and Analog Breakout Cable

(See the DVI Analog Breakout Adapter Instruction Card, part number 68-1172-01, [provided with the adapter], for pin assignments for this Y cable.)

DVS 510 Series • Installation 8