DVS 510 Series • Operation 40
MAX
MID
MIN
VOLUME
MAX
MID
MIN
VOLUME
MAX
MID
MIN
VOLUME
MAX
MID
MIN
VOLUME
MAX
MID
MIN
VOLUME
MIN LED flashes when
volume level is at
0% or audio muted.
MIN LED on solid when
volume level is at
1% or higher.
MID LED on solid when
volume level is at
50% or higher.
MAX LED on solid when
volume level is at
80% or higher.
MAX LED flashes when
volume level is at
100% (maximum).
Figure 23. Volume Indicator LEDs on the Front Panel

Audio or Video Breakaway

To switch the audio or the video separately away from the current input to another input
(audio or video breakaway), enter an audio or a video input selection SIS command (see
the Input Selection commands on page 55 in the Command and Response Table for SIS
Commands). When the audio is switched from one input to another (audio breakaway), the
audio switch effect is always a fade, regardless of the selected video effect. During audio or
video breakaway, the audio input button lights red and the video button lights green. Audio
or video breakaway is not available while the DVS is in PIP mode.
Resetting
The rear panel has a recessed Reset button that initiates various levels of resets. To select
different reset levels, use a pointed stylus or small Philips screwdriver to press and hold the
button while the DVS is running or press and hold the button while applying power to the
scaler.
NOTE: You can also reset the unit to factory defaults using SIS commands (see the
Resets commands on page 66 in the Command and Response Table for SIS
Commands) or from the front panel (see “Reset to Factory screen” on
page 33).
CAUTION: Review the reset modes carefully. Using the wrong reset mode may result
in unintended loss of flash memory programming, port reassignment, or
scaler reboot. The table on the next page provides a summary of the reset
modes.
NOTES: • The reset modes listed in the table on the next page close all open IP and
Telnet connections and all sockets.
• Each mode is a separate function, not a continuation from mode 1 to mode 5.
• There is no reset mode 2 for the DVS 510 Series.