Extron electronic DVS 510 SA manual DVS reverts to the factory, Default firmware for a single

Run and Stop Events Factory Firmware

Reset All IP Settings

Reset to Factory Defaults

DVS 510 Series Reset Mode Summary

Mode	Activation	Result		Purpose and Notes
1	Hold in the recessed Reset	The DVS reverts to the factory		Use mode 1 to revert to
	button while applying power	default firmware for a single		the factory default version
	to the unit.	power cycle. Event scripting does		for a single power cycle if
		not start if the unit is powered on in		incompatibility issues arise with
		this mode. All user files and settings		user-loaded firmware.
		(such as drivers, adjustments, and IP
		settings) are maintained.
3	Hold in the Reset button	Mode 3 turns events on or off. If		Mode 3 is useful for
	for about 3 seconds until	the events are currently stopped after		troubleshooting.
	the Power LED blinks once,	the momentary press, the power LED
	then release and press Reset	flashes twice, indicating the starting
	momentarily (<1 second)	of events.
	within 1 second*.
		If the events are currently running
		after the momentary press, the
		Power LED flashes three times
		indicating the stopping of events.
4	Hold in the Reset button	Mode 4 does the following:		Mode 4 enables you to set IP
	for about 6 seconds until	•	Enables ARP capability.	address information using ARP
	the Power LED blinks twice			and the MAC address.
	(once at 3 seconds, again at	• Sets the IP address back to factory
	6 seconds). Then, release and		default (192.168.254.254).
	press Reset momentarily (for	• Sets the subnet back to the
	<1 second) within 1 second*.
			factory default.
		• Sets the default gateway address
			to the factory default.
		• Sets port mapping back to factory
			default.
		•	Turns DHCP off.
		•	Turns events off.
5	Hold in the Reset button for	Mode 5 performs a complete		Mode 5 is useful if you want
	about 9 seconds until the	reset to factory defaults (except		to start over with configuration
	Power LED blinks three times	the firmware).		and uploading, and also to
	(once at 3 seconds, again	• Does everything mode 4 does.		replace events.
	at 6 seconds, again at 9
	seconds). Then, release and	•	Clears port configurations.
	press Reset momentarily (for	• Resets all IP options.
	<1 second) within 1 second*.
		• Clears all user settings.
		• Clears all files from the unit.

*For modes 3, 4, and 5, nothing happens if the momentary press does not occur within 1 second.

DVS 510 Series • Operation 41