Extron electronic DVS 510 SA manual Serial Configuration submenu, Set Dhcp Mode submenu

The flow diagram below shows the Edit Comm Settings screens and the adjustments that are available from them.

Press and hold

Next + [Detail+Color/Tint].

2 Sec.

Edit Comm

Settings

Next

	Serial Config		Next
9600		RS232

Set DHCP Mode

Off

Next

Set IP Address 192.168.254.254

Next

Select the baud rate:

Select the serial

Set the DHCP mode:

Set the IP Address:

Next

•

9600 (Default)

communication type:

•

Off (Default)

Select an octet.

Increase or decrease

•

19200

•

RS232

•

On

selected number:

•

38400

•

RS422

•

Range: 000 through 255

•

115200

•

(each octet)

Default: 192.168.254.254

Set Gateway Addr

Next

Set Subnet Mask

000.000.000.000

255.255.000.000

Set the Gateway Address:		Set the Subnet Mask:
Select an octet.	Increase or decrease the	Select an octet.	Increase or decrease the
•	selected number:	•	selected number:
	Range: 000 through 255		Range: 000 through 255
•	(each octet)	•	(each octet)
	Default: 000.000.000.000		Default: 255.255.000.000

Figure 21. Edit Comm Settings Menu

Adjustments can be made via the following Edit Comm Settings screens:

Serial Configuration submenu

1.Press Next until the Serial Configuration screen is displayed.

2.Rotate the horizontal Adjust knob ([) to select the baud rate. The available selections are 9600 (the default), 19200, 38400, and 115200.

Rotate the vertical Adjust knob ({) to select RS232 or RS422.

Set DHCP Mode submenu

When Dynamic Host Configuration Protocol (DHCP) mode is enabled, the scaler ignores any entered IP address and obtains its IP address from a DHCP server (if the network is DHCP capable).

On the Set DHCP Mode screen, rotate either Adjust knob to the right to turn DHCP on or to the left to turn DHCP off. Contact your system administrator for the setting to select.

DVS 510 Series • Operation 35