Extron electronic DVS 510 SA X2 , X1$ NP Nmp X2 , X1$, Advanced Configuration, X2 Test, X3& Vdly

Command	ASCII Command	Response	Additional Description
	(Host to Scaler)	(Scaler to Host)
Presets (continued)
Input Presets
Recall input preset	2 * X2^ .	2 Rpr X2^ ]	Recall input preset X2^.
Save input preset	2 * X2^ ,	2 Spr X2^ ]	Save the parameters of the current input
			to preset X2^ (for saved parameters, see
			“Input presets” under “Symbol
			Definitions for DVS 510 Series SIS
			Commands”).
Input Preset Name
Write preset name	E X2^ , X1$ NP }	Nmp X2^ , X1$ ]	Set name of preset X2^ to X1$. The
			command character is a comma. Presets
			can have up to 16 characters.

NOTE: The following characters are invalid in input preset names:
~ @ = ` [] {} <> ’ ‘ “ ” ; (semicolon) : (colon)			/ \ ? and space.
View preset name	E X2^ NP }	X1$ ]	View the name of input preset X2^.
NOTE: To clear an input preset name, enter one space character for X1$.
Auto Memories
Enable	E 1 AMEM }	Amem 1 ]	Enable auto memories to automatically
			recall the previous settings for the
			incoming signal (default).
Disable	E 0 AMEM }	Amem 0 ]	Disable auto memories. Input presets
			must be manually recalled to configure
			the input.
View setting	E AMEM }	X1) ]	View the status of auto memories.
Advanced Configuration
Test Pattern
Set test pattern	E X2) TEST }	Test X2) ]	Select test pattern X2).
View test pattern	E TEST }	X2) ]	View the current test pattern.
Freeze
Set freeze	1 F	Frz 1 ]	Freeze the selected input.
Set freeze	0 F	Frz 0 ]	Unfreeze the selected input.
View	F	X1) ]	Show the freeze status (1= on, 0= off).
RGB Delay Time
Set RGB delay	E X3& VDLY }	Vdly X3& ]	Set the time the DVS will delay displaying
			the new input to X3&.
View setting	E VDLY }	X3& ]	View the RGB delay setting.

NOTE: X1) = Auto memories or freeze status	0 = disabled, 1 = enabled
X1$ = Input preset name	Up to 16 characters; no special characters
X2) = Test pattern	0 through 13 (see “Test pattern” under “Symbol Definitions for
X2^ = Input preset number	DVS 510 Series SIS Commands” for the available test patterns).
	1 through 128
X3& = RGB delay amount	0 through 50 in 0.1-second increments. Default is 05 (0.5 seconds).
	DVS 510 Series • Remote Configuration and Control 63