Starting the Software

1.Click Start > Programs > Extron Electronics > Signal Processing > Signal Processing Products Control Program.

Alternatively, if an SPPCP icon was installed on the desktop, double-click the icon. The Select Connection Type window appears.

2.Select either the TCP/IP tab for an IP connection or the RS232 tab for a serial connection.

For an IP connection:

In the IP Address/Host Name field, either enter the IP address of your DVS or select the address from the menu.

NOTE: 192.168.254.254 is the factory-specified default IP address.

If you are using a port other than the default port 23, enter the port number in the Telnet Port field.

If the unit is password protected, enter the appropriate administrator or user password in the Password field.

For a comm (serial) connection:

Select the COM port from the Port menu.

Select the transmission rate from the Baud Rate menu.

Figure 34. Tabs on the SPPCP: Select Connection Type Window

3.Click Connect. The Signal Processing Products Control Program main window opens (see figure 35 on the next page), and the software is ready for operation.

DVS 510 Series • Remote Configuration and Control 80

Page 86
Image 86
Extron electronic DVS 510 SA manual Starting the Software, Tabs on the Sppcp Select Connection Type Window