Extron electronic DVS 510 SA manual X4%, Information Request, X1@

Command	ASCII Command	Response	Additional Description
	(Host to Scaler)	(Scaler to Host)
Advanced Configuration (continued)
HDCP Signal Status
Query input	E I HDCP }	X4$ ]	Request the HDCP signal status of the
			current input.
Query output	E O HDCP }	X4$ ]	Request the HDCP signal status of the
			DVI output.
Video Switch Effect
NOTE: The video switch effect also affects the audio switch, as discussed in the following command descriptions.
Cut	E 0 SWEF }	Swef 0 ]	Set the video switch effect to cut. The
			audio output is instantly switched to the
			next input.
Fade		Swef 1 ]	Set the video switch effect to fade
			(default). The audio ramps down from
			the current input, then ramps up to the
			new input.
View effect	E SWEF }	X4% ]	Show the current switch effect.
IR Receiver
Enable receiver	65 * 1 #	IRDisable 1 ]	Enable the IR receiver on the
			DVS front panel.
Disable receiver	65 * 0 #	IRDisable 0 ]	Disable the IR receiver (default).
View IR receiver status	65 #	X1) ]	View IR receiver status.

Information Request

General information I

Query firmware version	Q
Query part number	N

Vid X! • Aud X! • Pip X! • Typ X# • Std X1! ]

View the following device information:

Vid = video input

Aud = audio input

Pip = PIP input

Typ = video signal type

Std = video standard (X1!)

n.nn ]	View the current firmware version.
60-835-nn]	DVS 510	= 60-835-01
	DVS 510	SA = 60-835-02

View internal temp.	E 20STAT }		X1@ ]	View the internal temperature in degrees
				Celsius (response contains leading zeros).
NOTE: X! = Input selection		1 through 10
X# = Input signal type		1	= RGB, 2 = YUVp/HDTV, 3 = RGBcvS, 4 = YUVi, 5 = S-video, 6 = Composite,
X1) = IR receiver status		7	= DVI
		0	= IR receiver disabled; 1 = IR receiver enabled
X1! = Input video standard		0	= No signal, 1 = NTSC 3.58, 2 = PAL, 3 = NTSC 4.43, 4 = SECAM
		– = Not applicable (occurs when the input is set to RGB or YUVp/HDTV)
X1@ = Internal temperature		Shown in degrees Celsius with leading zeros
X4$ = HDCP signal status		0	= No receiver or source device detected (analog or digital inputs or outputs)
		1	= Receiver or source detected with HDCP/DPCP (digital inputs or outputs only)
		2	= Receiver or source detected but no HDCP/DPCP is present (analog or digital
X4% = Video switching effect		0	inputs or outputs)
			= Cut. Instantly switches audio output to the next input.
		1	= Fade. Audio ramps down from the current input, then ramps up to the new
			input (default).

DVS 510 Series • Remote Configuration and Control 65