Extron electronic DVS 510 SA manual Using the Optional IR 904 Remote Control, Output Sync Mute

Output Sync Mute

This function mutes all video and sync outputs, placing the display device in a power save mode. Output sync mute is available only via SIS commands (see the Video Mute commands on page 57, in the Command and Response Table for SIS Commands).

NOTE: Individual outputs cannot be muted by this command. With the output sync

mute enabled, all analog and digital outputs are simultaneously disabled.

Overscan Mode

This function allows you to set a default overscan of 0%, 2.5%, or 5% to apply to SMPTE input rates (NTSC, PAL, 480p through 1080p). When the overscan mode is not set to 0% and an auto-image is performed on a low-resolution or DVI input, the DVS uses the default values for input sizing and centering instead of performing a complete auto-image.

For YUV Auto and RGB inputs, pixel phase is included in the auto-image, regardless of the current overscan setting.

The overscan mode setting is adjusted per input type (composite, S-video, RGBcvS, YUV Auto, RGB, and DVI) using SIS commands (see the Overscan Mode commands on page 64 in the Command and Response Table for SIS Commands).

Using the Optional IR 904 Remote Control

The optional hand-held IR 904 Remote Control (part number 70-767-01) provides a convenient means of remotely performing many of the functions that are also available through the front panel, SIS commands, the Windows-based control software, or the embedded web pages. The DVS responds to commands from remote control as if the corresponding button were pressed on the front panel or the corresponding SIS command or software selection were entered.

The IR receiver port on the front panel is located to the left of the Config port. It receives signals from the remote control if they are sent from within a 40-degree arc to the right or left of direct line of sight between the remote control and the scaler IR sensor, and from no more than 30 feet (9 m) away.

		1	2	INPUTS	4	5	PIP	PICTURE CONTROLS
				3			PIP	SIZE	BRIGHT	DETAIL
							ON/OFF		/CONT
IR	CONFIG	6	7	8	9	10	PIP		COLOR	ZOOM
								POSITION
							SWAP		/TINT	/PAN

40 40

30’ (9.1 m) maximum

PIP

1 2 3 4

5 6 7 8

9 10

- + - +

- + - +

-+

IR 904

REMOTE

ADJUST	VOLUME
MENU	MAX
	MID
NEXT	MIN

DVS 510

DIGITAL VIDEO SCALER

DVS 510 Series Scaler

IR 904 Remote Control

Figure 24. Area for Remote Signal Reception

DVS 510 Series • Operation 43